FIRE PUMP MONITORING

This module communicates with the Smart communication manager console With Gateway through wireless communication. This module helps in monitoring The WEEKLY FIRE PUMP INSPECTION & TEST PROCEDURES. The purpose of the weekly Fire pump inspection and the test is to ensure the fire pump is in operating condition Condition and is capable of providing continuous delivery for required fire Protection demands. An additional purpose of the weekly test is to detect Deficiencies that may not be obvious by visual inspection. To prevent false Alarms, notification should be provided to the alarm monitoring facility prior to and after the completion of the weekly fire pump test. After the test verify that all Fire pump supervisory signals were received by the alarm monitoring facility The weekly inspection procedure should be completed prior to starting the weekly “Churn” test. The weekly “churn” test verifies the operational status of the fire pump and identifies deficiencies that may not be evident by visual examination. The system helps as a log of all the parameters without any human interference

 

 

FEATURES

·       Line Pressure sensor at the Fire Pump Room

 

·        Line Pressure sensor at the Roof Top (Optional)

 

·        Fire Tank water level in Liters

 

Jockey Pump

i. Monitors
Running Hrs

ii. Control
switch status: Auto/Manual

iii. Pump
status: On /Off

 

Hydrant Pump

i. Monitors
Running Hrs

ii. Control
switch status: Auto/Manual

iii. Pump
status: On /Off

 

Sprinkler Pump

i. Monitors
Running Hrs

ii. Control switch
status: Auto/Manual

iii. Pump
status: On /Off

 

Diesel Pump.      

• Monitors Running Hrs
• Control switch status: Auto/Manual
• Pump status: On /Off
• Fuel Tank Level in Liters
• Battery Coolant Temperature
• Lube Oil Pressure (optional)
• RPM (optional)
• Engine output water Temperature (Optional) .
• Engine input water Temperature (Optional